9. Making A Yeast Starter

 

White Labs Pitchable Yeast is packaged with 70 to 140 billion yeast cells, which corresponds approximately to a 1-2 litre size starter. Lag times are typically between 12-24 hours for a normal strength brew.

 

A yeast starter is used to initiate cell activity or increase the cell count before using it to make your beer. The yeast will grow in this smaller volume, usually for 1-2 days, which then can be added to 5 gallons of wort.

 

While a starter is not always necessary, White Labs recommends making a starter if the  Original Gravity is over 1.070, if the yeast is past its "Best Before" date, if you are pitching lager yeast at temperatures below 65F, or if a faster start is desired.

 

Procedure:

In a medium sauce pan, add 1000ml of water and 200g Dried Malt Extract (DME).  Mix well and boil the solution for about 5 minutes to sterilise. Cover and cool the pan to room temperature in an ice bath if necessary.  This will give you a wort of approximately 1.040 OG.  Keeping the Original Gravity low is important because you want to keep the yeast in its growth phase, rather than its fermentation phase.  The fermentation phase will create alcohol which can be toxic to yeast in high concentrations.

 

Pour the wort into a sanitized glass container (demijohn) and pitch the vial of yeast. Put an airlock and bung on the demijohn which will allow CO2 to escape.  Vigorously shake or swirl the container to get as much oxygen dissolved in the solution as possible.  Keep the starter at room temperature for 12-18 hours on a magnetic stir plate if you have one, or occasionally shaking it to keep the solution aerated.

 

You probably won’t see any visible activity, but the yeast is busy taking up the oxygen and sugars in the solution and growing new cells.  After 18 hours, the yeast will have consumed all of the nutrients and oxygen in the starter.  Switch off the stir plate or discontinue shaking and it will form a milky white layer on the bottom of the container as the yeast flocculates.  If you are not planning on pitching the yeast right away, you can store it in the refrigerator to get it to settle out quicker.

 

When you are ready to brew, decant off most (80%) of the clear liquid from the top, being careful not to disturb the yeast layer below.  Once the yeast and your wort are at approximately the same temperature, rouse the starter yeast into suspension with the remaining malt solution and pitch the yeast slurry into your wort.

 

Typical Starter Volumes for 5 gallons:
To activate the yeast: 500ml (100g DME)
To revitalise yeast past its Best Before Date:  1000ml (200g DME)
To brew a high gravity beer: 1000ml (200g DME)
To brew a lager beer, starting fermentation 50-55F: 2000ml (400g DME)


     
There are no products to list in this category.